North American SDS
Cosmofen Plus PVC Adhesive
Product # SA2130A
Good temperature resistance and UV-radiation
Fast structural bonding of rigid PVC window construction parts. It can used on additional profiles, such as sill drips, drain bars, blow bars, shutter bars, and for sanitary areas, such as bonding of tubes, guitter pipes, and others.
Product # | Finish/Color |
---|---|
SA2130A | Almond |
SA2130CL | Clay |
SA2130 | White |
ADVANTAGES AND BENEFITS
* Tough-hard adhesive joint
* Thixotropic, does not drop off
* Good temperature resistance
* Good UV-radiation resistance
* Thixotropic, does not drop off
* Good temperature resistance
* Good UV-radiation resistance
TECHNICAL SPECIFICATIONS
Product #
SA2130A
Weight
180 g
Viscosity
4000 mPa.s
Recommended Use
Door and Window
Material
PVC
Drying time (approx.)
24 hours
Open time (approx.)
60 seconds
IMPORTANT INFORMATION
-The time parameters specified here can only be determined accurately by self-tests because they are strongly influenced by material characteristics, temperature, applied quantity, air humidity, material humidity, thickness of
adhesive film, press power, and other criteria. Usually, appropriate safety factors are considered for the guiding values.
-Density as per EN 542 at +20 °C (+68 °F) approx. 0.99 g/cm3 (8.26 lb/gal).
adhesive film, press power, and other criteria. Usually, appropriate safety factors are considered for the guiding values.
-Density as per EN 542 at +20 °C (+68 °F) approx. 0.99 g/cm3 (8.26 lb/gal).
APPLICATION
-Applied quantity (for bonding of battens);
20 mm (0.79") wide bonding surface approx. 8 g/running metre (0.28 oz/running meter)
40 mm (1.57") wide bonding surface approx. 16 g/running metre (0.56 oz/running meter)
-Minimum processing temperature from +5°C (+41°F)
20 mm (0.79") wide bonding surface approx. 8 g/running metre (0.28 oz/running meter)
40 mm (1.57") wide bonding surface approx. 16 g/running metre (0.56 oz/running meter)
-Minimum processing temperature from +5°C (+41°F)
DISCLAIMER
-The bonded joint is loadable after 16 h, the remaining hardening time of the bonded joint can last up to 8 weeks or depending on the conditions.
-Diffusion adhesives can only bridge over bonded gaps of <0.1 mm (3.9 mil) in a tensionally locked way.
-Diffusion adhesives can only bridge over bonded gaps of <0.1 mm (3.9 mil) in a tensionally locked way.