Rectangular Glass Clamp - Flat Post Mount - Model 509

To add to cart, choose from the options below.

65 mm height with detachable safety lock pin and safety plate

Set of two rectangular clamps for installation of a glass panel between two square posts.
The optional safety lock pin is included to keep the glass in place and prevent the glass from sliding.
An optional safety plate for face mount installation of posts included -- no pre-drilling required.
A set of protective joints, sold separately, is required for installation.
Recommended Location Usage: Interior Interior / Exterior Material: Stainless Steel 304 Stainless Steel 316 Select Options
Product # Recommended Location Usage Material
HRGCS450900170 Interior Stainless Steel 304
HRGCS650900170 Interior / Exterior Stainless Steel 316

ADVANTAGES AND BENEFITS

Increases glass stability when used with end plate or safety lock pin.

No glass drilling required when using the safety plate.

End plate is equipped with rubber stops, to prevent the glass from moving after installation, even if used without the safety lock pin.

REQUIRED PRODUCTS

Requires ONE of the following products
Set of Gaskets for Rectangular Glass Clamps
  • Glass Type: Tempered
  • Safety Glass Thickness: 10 mm
Product # HRGCG5091000
Box of 4
OR
Set of Gaskets for Rectangular Glass Clamps
  • Glass Type: Tempered
  • Safety Glass Thickness: 12 mm
Product # HRGCG5091200
Box of 4
OR
Set of Gaskets for Rectangular Glass Clamps
  • Glass Type: Laminated
  • Safety Glass Thickness: 12.76 mm
Product # HRGCG5091276
Box of 4

TECHNICAL SPECIFICATIONS

Type of Mounting
Wall Mount, Post Mount
Finish
Stainless Steel
Safety Glass Thickness
10 to 12.76 mm
Height
65 mm
Width
37.7 mm
Length
55 mm
Baluster Post Type
Square Tube
Milling Diameter
12 mm

APPLICATION

Ideal for designing railings and glass balustrades with handrails.

INCLUDED PRODUCT(S)

Set of two rectangular clamps.
Stainless steel safety lock pin covered in rubber.
Detachable safety plate with rubber stop.
M8 mounting screws.
Screw cap.

IMPORTANT INFORMATION

Not using the safety lock pin during installation may result in the glass sliding.
Glass drilling is required when using the safety lock pin.

Make sure to use proper joints according to the glass thickness.

For safety purposes, use tempered glass.

This illustration is provided for visual reference only. Actual product may vary. Order hardware before starting the job. The manufacturer reserves the right to change product and information without notice. Always follow the instructions inside the package.

Drawings and technical documents contain examples of hardware from different manufacturers. The customer may not in any case make a claim following the use of these documents. The Company disclaims any responsibility for the structural details related to a construction or project.

Installation must always be done by qualified personnel. Make sure that the product is properly installed using suitable fixtures on the support material.

RELATED DOCUMENTS

DISCLAIMER

The preceding information, as well as any technical recommendation given in writing or verbally, whether based on tests or not, is provided to the best of our knowledge. Recommendations are non-binding and do not diminish your responsibility for determining the correctness of these recommendations and the suitability of the product for your particular purpose.

The application, use or processing of our products, as well as the execution of projects based on our technical recommendations are beyond our control and therefore exclusively your responsibility.

Sales of our products are subject to our most recent General Sales and Delivery Conditions. Please note that Richelieu will not accept any returns or claims for unpackaged products.